We will be glad to help and assist you in finding the crossword clues for the following clue: Water conduit.
looking at this crossword definition, it has 13 letters.
for better and easier way of searching the for a crossword clue, try using the search term “Water conduit crossword” or “Water conduit crossword clue” while searching and trying to find help in finishing your crosswords. Here are the possible answers for Water conduit.
We hope you found what you needed!
If you are still unsure with some definitions, don’t hesitate to search for them here in our site using the search box on top.
Possible Answers:
PIPE.
Last seen on: NY Times Crossword 1 Nov 22, Tuesday
Random information on the term “Water conduit”:
In modern plumbing, a drain-waste-vent (or DWV) is a system that allows air to enter the plumbing system to maintain proper air pressure to enable the removal of sewage and greywater from a dwelling. Drain refers to water produced at fixtures such as sinks, and showers; waste refers to water from toilets. As the water runs down, proper venting is required to allow water to flow freely, and avoid a vacuum from being created. As the water runs down air must be allowed into the waste pipe either through a roof vent (external), or an internal vent.
DWV systems maintain neutral air pressure in the drains, allowing free flow of water and sewage down drains and through waste pipes by gravity. It is critical that a sufficient downward slope be maintained throughout the drain pipes, to keep liquids and entrained solids flowing freely towards the main drain from the building. In some situations, a downward slope out of a building to the sewer cannot be created, and a special collection pit and grinding lift “sewage ejector” pump are needed. By contrast, potable water supply systems operate under pressure to distribute water up through buildings, and do not require a continuous downward slope in their piping.
Random information on the term “PIPE”:
A pipe is a tubular section or hollow cylinder, usually but not necessarily of circular cross-section, used mainly to convey substances which can flow — liquids and gases (fluids), slurries, powders and masses of small solids. It can also be used for structural applications; hollow pipe is far stiffer per unit weight than solid members.
In common usage the words pipe and tube are usually interchangeable, but in industry and engineering, the terms are uniquely defined. Depending on the applicable standard to which it is manufactured, pipe is generally specified by a nominal diameter with a constant outside diameter (OD) and a schedule that defines the thickness. Tube is most often specified by the OD and wall thickness, but may be specified by any two of OD, inside diameter (ID), and wall thickness. Pipe is generally manufactured to one of several international and national industrial standards. While similar standards exist for specific industry application tubing, tube is often made to custom sizes and a broader range of diameters and tolerances. Many industrial and government standards exist for the production of pipe and tubing. The term “tube” is also commonly applied to non-cylindrical sections, i.e., square or rectangular tubing. In general, “pipe” is the more common term in most of the world, whereas “tube” is more widely used in the United States.